This is almost always diagnosed as clumsiness and it almost never is. Over 60 there is a specific mechanical reason mascara ends up on the lid, and understanding it turns the problem from a question of steadiness into a question of position.
The upper lid loses elasticity and begins to rest lower. Where it once sat clear of the lash base, it now comes down onto or very near it. So at the moment the lashes are wet, there is lid skin within a millimeter or two of them — and any blink, any upward glance, any small movement of the brow presses that skin against wet product. The print on the lid is not a miss. It is contact.
Standing in front of a wall mirror makes it certain. Looking up or straight ahead at a mirror keeps the eye open and the lid down over the lash base, which is the single worst position for this. Looking down at a mirror lying flat on the table does the opposite: the lid rises away from the lash line, the lashes stand clear, and the wand has somewhere to go. The same position is the one that makes tightlining possible, and for the same reason.
Second cause: too much product on the wand. A loaded brush deposits more than the lash can hold, and the surplus is what transfers. Drawing the wand once across a tissue removes that surplus and costs nothing.
Third cause: not letting it set. A wax film stays tacky for a surprising number of seconds, and a normal blink in that window prints the whole lash pattern onto the lid. Holding the downward position for twenty seconds after the pass is unglamorous and it works.
And fourth: formula. If contact happens anyway — and with a very hooded lid it sometimes will — what matters is what it does next. A tubing mascara forms a polymer tube around each lash and comes off in whole tubes with warm water, so a mark on the lid lifts away cleanly. A traditional wax mascara smears, and smearing on thin lid skin means rubbing, which is the thing to avoid.
What to look for in the products, then. A tubing formula for clean recovery; a grip you can hold steadily at an awkward angle, because looking down into a table mirror is a less natural arm position than facing a wall; and a mirror that stands on its own so neither hand has to hold it.